Well i have been working on the van again. Its going slowly at the moment but that is to be expected. I’m trying to reuse panels off the donor van which slows things up a bit but its saving me money.

I remembered a few important rules about welding today. Never wear loose sleeves. I have loads of burns to prove it!! Always wear a hat under the welding helmet. I have a burned forehead, you’d swear i was out summing myself. Then again i didn’t get this burned all last summer!!

Started with the passenger side rear quarter panel. The rusty panels where cut out.

And replaced.

They will look good when they get a light coat of filler. I just used a bit of areosol primer to keep them protected until i get to the bodywork.

I started filling all the small holes in the passenger side of the body. Got most of them done. I was going to move on to the front half of the arch on the rear but the repair section which i was going to use was full of fillers so no point putting it on. I’m going to have to leave it until i can get a repair panel in.